Recent content by steveleb

Took the head off and cleaned the head and top of the block off. With a plastic scraper and starting fluid. I am replacing the head gasket and I need to know the torque sequence and how many pounds to torque the bolts. Its a 126T07 4226-B1. Thanks for your help.

The build date of the mower has 04/09 on the barcode. Compression test was done with a gauge same one I check the compression of my cars.

I tried a compression check 0 no compression. I was attempting to pull the head and the middle bottom bolt had oil on it. Don't think that's normal. When that happened is stopped and didn't remove the head.

I sprayed starting fluid in it and it didnt start, but when I tried to start it i heard compression out of the carburetor. Is that normal?

I have a 20095 key operated model. The battery is gone and the key also. the wires to the have been cut off and no ignition switch and it wont start. Is there any of those wires should be connect to start the mower. The two red wires are not connected to anything.

Thanks for your help, but do you agree that it looks like it won't fit. Thanks again

Sorry that one doesn't look like that would fit.

Are you looking for the serial number of the coil or the mower it self? Both are in my reply yesterday. Serial #8906752

Thats the numbe on the coil. Serial #8906752

What coil would you suggest to replace an original 682337.

I don't think it has points.

Thanks I just read your reply to another post. Thanks Again Just to ask its a 79-80 mower. Would there be a difference?

I was checking the coil on the multimeter and it reads .41. Good or Bad

Thanks for the help.

sorry looking for which color wire that goes to the coil