slomo's latest activity

NICE JOB sgkent!! The plug on the right is the offender. Look at all the carbon tracking trying to ground out to the base ring of the...

the plug that has the heli-coil or timesert - you may have been losing your plug ground with that if it was loose and soot was filling...

Just drain the entire fuel system. He's not working on a container ship here.

I got almost 2000 hours out of a Kohler Command engine in my Scag before a rebuild, with zero extra zinc added or anything except 10W-30...

Were you on the heel of the cam when you adjusted clearance? Most four stroke engines have 2 TDC strokes.

1.Adjust valves to factory specs for YOUR engine. 2.LOAD test battery. 3.Clean all grounds.

I thought the last miracle research about zinc and phos was that, they did zero for engine wear? Google says zinc is good for hi temps...

Better yet, grade the slope up with some rich mix top soil and 10% compost. Take the steepness out of the slope. It will at least...

I wouldn't mow any slope unless it was a full pressure lubed engine mower. Even then check the max slope angle.

I'm seeing more than a drain issue. Tons of rust on those grounding points. Bet the entire block is covered in mud. What cooling fins...

Little detective work and she is mowing again. Nice job.

unusual issue. Many of these carbs the last 20 years use a couple small punch marks to hold the butterfly in place, and no screws...

Thanks for letting us know B, These are occasionally "slide in" throttle blade (on some models). If it has a small center screw, it...

My canola oil is better than all these combined.

Hope she got it going ok.