slomo's latest activity

Should be. Keep at it. Sounds like you are making good headway on her.

Appreciate it fellas. Idle arm was bent a bit. Flattened it back out with a BFH on the anvil vise. Idler pulley sounds rough so going...

Running good so far. Keep up the good work fellas'.

Bad idea not so much. Better than it was for sure what you did. I use Mother's Mag Wheel Polish. Or Flitz is great too. There are...

Used a toothbrush sized brush with brass bristles on the switches. Is that a bad idea? How would one polish them? That's a new...

Maybe they forgot that they posted a help request? I give people benefit of the doubt. (Got bigger things to worry about in life)

with respect to you and others that answer people that don't give a response to the help that you gave them to let you know you were...

Gas cap vent Poor fuel delivery AT carb inlet. Dirty carb. Weak spark.

Read up on dynamic compression.

No spark Remove coil. Polish the coil mounting pads and coil where it sits on the pads. Coil needs a clean ground to make spark. Still...

Look into this. Checked with what? Should be something in the fuel rail to loosen as to create a leak for testing fuel pump. Close to...

Did you get this fixed?

A needle is needed on the float inside the carburetor. That or the float is heavy with fuel inside of it. After that the oil will need...

97% of the time that is the result of a float valve that has not sealed and has allowed the carb to empty the entire contents of the...

faulty needle and or float in the carburetor, not metering fuel flow into the carb. repair or replace carburetor drain and refill...