Recent content by slinger2

  1. S

    Trying to chose between two Timecutter MyRides.....?

    Sam, Were you able to order a 75745 for $3699? If so I'm going to give my dealer hell for not being able to get one for me!
  2. S

    Trying to chose between two Timecutter MyRides.....?

    I don't think your dealer really checked with Toro on the 75745's availability, and certainly not for $3699. I just spoke to Toro, and unless you can find one of these at a dealer, you cannot order one from the factory. Why don't you check again or call Toro before you try to make a decision on...
  3. S

    Trying to chose between two Timecutter MyRides.....?

    Just slightly...I think it came out around 2020-21, but there haven't been many updates at all to the Timecutter since then so I would jump all over that model if you could get it for $3699 as you stated. There should be plenty of parts for those engines down the road if you need them. The...
  4. S

    Toro Timemaster won’t turn off

    Most of the time it's because you have to hold down the shutoff switch until the mower stops. If you let go too soon the contact breaks because it is a momentary switch and the engine keeps running. If that is not it I don't know....
  5. S

    Increasing rear tire size on Toro 42 inch Timecutter

    Will you be able to adjust the deck height and rake properly after jacking up the rear of the mower like that?
  6. S

    Trying to chose between two Timecutter MyRides.....?

    FYI you will probably not find a 75745 anywhere, and if you do, it won't be for that price! Even used, that (slightly older) model is hard to come by. I find the Toro engines to be built just as well (even better in some aspects!) as the Kohler so I would not let that sway your opinion...
  7. S

    Toro Engines ? Who is making them ?

    Videos on these engines. I have heard the Toro engine is being discontinued next year because of cost - not performance. The V-Twin lawsuit from B&S on foreign made engines, Tariffs, and shipping have all made importing v-twin engines unrealistic at this time.
  8. S

    Toro TimeMaster (30") makes an odd noise when blades are engaged

    Sounds like a bearing failure to me. Remove the blade drive belt and spin the blades by hand to see if you feel any roughness. Spin the pulleys by hand to see if there is any slop, wobble or roughness in them as well. If the spindle bearings are bad, they can usually be replaced without...
  9. S

    Recommendation for cordless self propelled 21” mower

    There is no battery push mower currently that can match a good gas powered mower for power and suction. Battery mowers have thinner, lighter blades with much lower lift characteristics (lower sail) because this reduces the air resistance against the blade which helps with battery run time. And...
  10. S

    Toro 22" 60V Recycler mower blade

    Anyone notice that the blade on the new Toro 22" 60V recycler (model 21466) only measures 21 1/4" long? That's not a 22" mower. Has anyone tried any other blades on this mower? Most blades up to 21 3/4" long will fit as long as they have a 7/16" dia. center hole, and as long as the blade sail...
  11. S

    New Ryobi dual blade lawn mower

    I bought one of these after trying a previous Ryobi model (less expensive one) that had a bad speed control switch for the self propel drive. Upon inspection this new Crosscut model Ryobi had 3 large screws stripped out in the plastic deck. These screws held the metal plates where the handle...
  12. S

    Toro enhanced Recycler's new Vortex Technology feature

    I was wondering if you were mulching, what keeps debris from being blown up through the vent, since you don't have the large exit area as during side discharge or bagging?
  13. S

    Toro enhanced Recycler's new Vortex Technology feature

    From Toro news room: "Toro has been long recognized as the innovator in helping customers care for their property," notes Aran Brosnan, senior marketing manager at Toro. "Part of that innovation includes new features, such as the Vortex Technology™ on the enhanced Recycler mowers, which...
  14. S

    Timemaster blade drive V belt insanity

    I had a similar issue. On my 2012 I noticed the belt tensioner arm vibrating like crazy. I removed the tension idler arm and noticed that the spacer (p/n 138-3244) which is the shoulder bolt type piece that the idler arm and friction washers mount on had a big groove worn in it from the belt...
  15. S

    Timemaster starts with pull rope but not with electric start

    I will change the carb for $14. If that doesn't solve it I will get the valves adjusted. It seems to turn over at the right speed, and once it starts, it runs perfectly. Thanks for the suggestions.
Top