sgkent's latest activity

  • sgkent
    sgkent replied to the thread Oil measurement question.
    you are going to get many conflicting answers on this. Many dipsticks that screw in have a notch that allows a bump on the dipstick to...
  • sgkent
    sgkent reacted to Tiger Small Engine's post in the thread Rocking Key with Like Like.
    Sounds like the last few years you have experienced some health problems. Try to take things a little slower and take care of yourself...
  • sgkent
    sgkent replied to the thread Part and O-ring size?.
    Did you try Google? I put the carb type in, found...
  • sgkent
    sgkent replied to the thread Rocking Key.
    yes. that is why I posted it, in case someone is searching it. When I cleaned it and put it back together after rebuilding the engine, I...
  • sgkent
    sgkent reacted to Rivets's post in the thread Rocking Key with Like Like.
    I wish I had a nickel for every time I’ve seen a DIY guy make this mistake. In 40 years working on Toros I could but myself a good...
  • sgkent
    sgkent replied to the thread When a battery is really DEAD.
    they are about the cutest and worst animal ever created on earth.
  • sgkent
    sgkent posted the thread Rocking Key in Toro/Wheelhorse.
    we have a Toro 20055 that is about 2006 vintage. I went thru the engine a month or so ago, and basically remanufactured it after 20...
    • rocking washer.jpg
    • rocking key.jpg
  • sgkent
    sgkent replied to the thread Random dead miss..
    the first time I came across bad new plugs was in 1972 on the way from Pasadena CA to the SF Bay area. Sports car would start missing...
  • sgkent
    make sure you monitor battery voltage when you try to start it. You won't be the first person to be fooled by a battery that shows 13V...
  • sgkent
    does it have any sensors like an oil sensor that check to see if it is safe to continue running? If yes, check there. If no then you...
  • sgkent
    sgkent replied to the thread New deck belt not disengaging.
    sounds like the belt is mis-routed, too wide, too tight, or the wrong belt.
  • sgkent
    use some flammable carb cleaner, Berryman's B12, or propane around the intake manifold first to look for vacuum leaks. disconnect the...
  • sgkent
    sgkent replied to the thread Leaking crank seal.
    could or the breather could be plugged or head gasket leaking combustion into the oil passage.
  • sgkent
    sgkent replied to the thread Random dead miss..
    based on the choking, unless there is residual water, which I doubt based on your attention to detail, it is probably something like a...
  • sgkent
    sgkent replied to the thread Random dead miss..
    A lean misfire can be a mixture that is right on the edge of being lean so any deviation leaner can cause a random misfire. I'd use the...
Back
Top