sgkent's latest activity

  • sgkent
    sgkent replied to the thread Leaking crank seal.
    could or the breather could be plugged or head gasket leaking combustion into the oil passage.
  • sgkent
    sgkent replied to the thread Random dead miss..
    based on the choking, unless there is residual water, which I doubt based on your attention to detail, it is probably something like a...
  • sgkent
    sgkent replied to the thread Random dead miss..
    A lean misfire can be a mixture that is right on the edge of being lean so any deviation leaner can cause a random misfire. I'd use the...
  • sgkent
    sgkent replied to the thread walbro or Nikki carb.
    https://www.walbro.com/wp-content/uploads/2017/05/Walbro_Float_Carburetors_DS_EN.pdf
    • lmt.jpg
    • lmt2.jpg
  • sgkent
    sgkent replied to the thread Random dead miss..
    try replacing it with a known good used spark plug since the guy put his own in, unless he will pay for a new one. There are so many...
  • sgkent
    sgkent replied to the thread Flywheel adapter 611032.
    if it is two cycle don't forget the oil if it uses a 2 cycle mix.
  • sgkent
    sgkent replied to the thread 8HP Briggs Governor Shaft Leak.
    check the oil level, and for gas in the oil
  • sgkent
    sgkent replied to the thread When a battery is really DEAD.
    wiring replacement after a fire or overcurrent melt is about the worst job out there. I excel at finding and fixing electrical and...
  • sgkent
    I usually use a loop of wire around any spring that I can't pull with vise grips or some kind of spring puller like auto drum brakes take.
  • sgkent
    sgkent replied to the thread Flywheel adapter 611032.
    Unless the spark plug was from a known good source, I'd try another. Then I would blow the cylinder out with compressed air to dry it...
    • adapter.jpg
  • sgkent
    sgkent replied to the thread Carb Cleaning Question.
    FYI - regular simple green will dissolve some carbs. The HD Metal Safe version doesn't do that. Home Depot is the easiest place to get...
  • sgkent
    there was a youtube on it recently. The new caps lack the hole. It has to be in a certain spot to stop gas from sloshing out. Starts...
  • sgkent
    sgkent replied to the thread Carb Cleaning Question.
    set it into the fluid in a way that the air can get out. Use "Simple Green Pro HD SAFE FOR METALS" with hot water and you will get metal...
    • hd.jpg
  • sgkent
    most lead acid batteries are degraded enough by 4 years to replace them. Some people consider 50 - 60% life left good. Others replace...
  • sgkent
    sgkent replied to the thread Chop saw carb prob..
    did you check the three lines to be sure they are on the correct nipple?
Back
Top