SeniorCitizen's latest activity

The X300 wiring diagrams show two fuse links. One from the B+ of the voltage regulator to the Battery side of the starter solenoid. The...

I'm thinking there is still a fuel problem for what reason ????. With the air filter out and a dribbler of gasoline into the carb...

I mow a clay soil ditch with a X350 and if a tire gets any wet on it i find something else to mow . String trimmers don't seem to get...

https://www.amazon.com/Silca-Thread-on-Schrader-Chuck/dp/B00YTE788U/ref=sr_1_9?dib=eyJ2IjoiMSJ9.Q5g0vYVS7cYgMYHTt9YiFso4L47XJ2ohLmzZqjjxc...

I had a John Deere that wouldn't start cold but started fine otherwise . The solution after so much aggravation i drilled a 1/8" hole in...

Check timing by watching the spark while you have your thumb pressed firmly on the spark plug hole . While a helper is cranking it , If...

Maybe grinding a radius in the side of the chisel that is approximately the same radius as the cone would help with removal .

These are commonly use trailer and automotive bearings and should last for years as long they are kept greased. And some of us do than...

Size a wood dowel that will screw into the hole by measuring the ID of the hole and add 0.020" . Then you can get a better idea of...

Sorry the 807778 is straight PTO but that's what the IPL showed. Apparently someone swapped crankshafts, here is a couple of the Taper...

I don't care much for clamp connections for hose so this is what i do . Place the hose beside the barb end and mark on the hose , with...

If your bike tire is a little low on pressure and you don't have a compressor or air tank ( with air ) a hose can be made to steal a...

Good point Bert..

Ace hardware, Tractor Supply..