Recent content by S.A.E.

Thank you for that information. I understand that in position 4 (from the highest setting), the deck will not raise any further. I might re-visit that issue later after viewing my neighbor's machine. I would be interest to know that is preventing further "up" travel of the deck (unable to...

Until I get you some pics, ....are you satisfied that the deck raise handle, it's mechanisms and rods below the seat, the cable lift pulleys, the lift arms, and the cables themselves are in spec? (correct, not bent, not stretched, correctly bushed, and properly routed?). That the...

Are you satisfied with the range/travel offered by the height adjustment lever at the side of the seat? thanks

Sorry, I only had your most recent post in view at the time of my response to you about the hole location: self drilled or not. Will reload the thread now that I know you were the original poster

Though I thought about drilling, there were several pre-drilled holes not being used by the factory. I'll be back to the machine sometime soon and will follow up with a pic. I wish I had a photo in my possession to demonstrate. What issues are you experiencing? thanks Scot

Just helped a neighbor with the BS ScrubCadet stupid leveling contraption. His 2012 USA (not AU)1050(?) would not raise enough to allow cutting thru Bermuda and eject properly and with force at a height above about 2 inches. His mower's issue was that even at highest settings possible...