Recent content by Rooster7

I was blowing snow the other night and suddenly the auger quit turning on the blower. No clunks or noise. The shaft behind the sprocket box turns but the auger doesn't. I'm assuming it's something in the sprocket box. My question is, do I need to replace the whole sprocket box (very expensive)...

I was blowing snow the other night and suddenly the auger quit turning on the blower. No clunks or noise. The shaft behind the sprocket box turns but the auger doesn't. I'm assuming it's something in the sprocket box. My question is, do I need to replace the whole sprocket box (very expensive)...

What do people specifically have against the Kawasaki? I just bougtht a Hustler Fastrac with a 24 hp Kawi on it. Every other Hustler machine the dealer had also had Kawi engines? If they are so bad, why would Hustler risk their reputation on them?

I'm looking at getting a Hustler Fastrac ZRT. I mow 4 acres that is going to turn into closer to six next year when I plant grass around my tree rows. Anyway, I was thinking of going with a 54" deck but my cousin who is in the lawn care business said not to go bigger than 48" because I will...

I'm looking at getting a Hustler Fastrac ZRT. I mow 4 acres that is going to turn into closer to six next year when I plant grass around my tree rows. Anyway, I was thinking of going with a 54" deck but my cousin who is in the lawn care business said not to go bigger than 48" because I will...

I joined this forum after receiving an email that it existed. I used it to get advice on mower problems. I admit that I have not been on for some time but now that I am again, I'm seeing a lot of frustration from the guys that know and want to help. They can't help trouble shoot your problem...

I got the bolt out and it won't budge so I took the hood and grill off in order to get a clutch puller on it. The exhaust guard is in the way so I kind of angled the puller so I wouldn't have to remove the entire exhaust. I tightened the puller to the point of bending the pully and that dang...

I have a 6' 3-point King Kutter mower that I purchased used. It was time to change blades and they won't even budge with a 1/2" DeWalt impact wrench. I have never seen bolts rusted on this bad. I'm hoping that if I just keep spraying Deep Creep etc. on that they will eventually loosen up. Has...

My FIL was using my Cub 2186 mower and the front headlight assembly fell out and he ran over it. I replaced it and they worked fine. Then all of a sudden they just quit working. I replaced the fuses under the dash panel and still nothing. :confused2: The headlights are turned on and off by...

This site is awesome! I just joined today and already have found it helpful. Maybe this is the wrong spot to post this but: What I would like to see is a sticky photo thread that would identify all the different lawn weeds and the best way to get rid of them. This way people can just go to one...

I have a Cub 2186 44" Deck and 42" Blower. This winter, I went to start the tractor and the blower started running without the PTO switch pulled out. When I did pull the switch out, it seemed to run a little faster. Now its mowing season and I put the deck on and started it, forgetting about...