Recent content by Roll

  1. R

    I'm searching for help with a Generac 212 engine (2000 to 3100 psi Power Washer). Got it started but will only run with the choke full on.

    Removed the carb and disassembled. I followed the video, cleaned it up. I also found the main jet blocked. Reassembled and installed. Power washer started on third pull and ran like it was new. Thanks Scrub!
  2. R

    I'm searching for help with a Generac 212 engine (2000 to 3100 psi Power Washer). Got it started but will only run with the choke full on.

    Perfect. Watched all the way through. May DL to laptop and take that out to the shop. Thanks again.
  3. R

    I'm searching for help with a Generac 212 engine (2000 to 3100 psi Power Washer). Got it started but will only run with the choke full on.

    Thanks Scrub. I was going to pull it off tomorrow morning, so I'll go through it and clean out any residue.
  4. R

    I'm searching for help with a Generac 212 engine (2000 to 3100 psi Power Washer). Got it started but will only run with the choke full on.

    This 2012 212 engine will start and run but only if I keep the choke pulled all the way out, (full on choke setting). Once running the unit runs steady then spits occasionally which I expect is a misfire. The choke will eventually start to creep down via vibration. When that happens the engine...

Footer Links 1

Top