Recent content by rinse

Decided to start with the seat safety switch. Jumped the connectors and it fired right up. So I cleaned out the plug and a decent amount of dirt came out. Hook it back up and it run now. Thanks for the reply!

I was mowing and my zero turn engine died out of nowhere (26hp Kawasaki). So I immediately thought it was the seat safety switch, ordered a new one, installed it nothing. In addition I have checked the following: Ignition switch - signals continuity at the correct posts in all positions Relays...

Would a faulty voltage regulator on a FD731V-BS00 cause relays to blow and the fuse for the charging system to blow? This started a few weeks ago, I replaced the relays and it ran for two weeks, they popped again and replaced the relays then ran for about 10 mins before they blew. When I went...

Ended up being a bad relay. Thanks for everyone’s input!

In the start position I am getting 12.6x volts from B/LS and the run position I get 12.6x volt from B/L/A.

Family ID: 7KAXS. 6752CB Engine family: KAXS. 675N4CC E/NO FF731V030924

i believe it is. I will double check.

Just checked grounds and voltage on the key switch. I was getting 12.65 volts at all positions on the switch required to start the engine, still not engaging the starter solenoid. Is there an east way to test the safety switches or could the time delay module have gone bad and caused the issue?

The motor is on a Ferris is3100z.

I believe I have a Kawasaki FD731V. Recently my wife was driving the mower and it just died in the middle of the yard. It has fuel and good battery but, when I inspected the fuses, the 20A fuse for the charging system was practically melted. I removed the fuse and cleaned the terminals but...

I have an IS3100z with the 26hp Kawasaki (FD731V) that has issues starting. I'll try to run through what I have done and hopefully someone can point me in the right direction. Background: I bought this mower used, started fine, get it home and issues with the mower starter engaging, the...