Recent content by red423

I disassembled the pulleys for the drive belt and transition belt assy am going to reasemble when I can is there anything special I need to pay attention too? those spring loaded varible drives are just a take off of a modern torque converter used on numerous machines. the shaft that holds the...

thank you for the reply, upon my own digging I have a RS800LR which of course is discontinued. So if anyone has an RS800LR diagram would massively appreciate it. I get my replacement parts today, due to weather still have a day or two before I start repairs, Thanks again, R

Was gifted a YTA24v48, Ser. 960450052 got her running engine wise, still have to clean idle jet, BUT the traction belt is so worn out , pulled it down, while trans still in unit, I forget at times, seems old age is a terrible thing, anyway I forgot order of belt plates and cone washer placement...

a 960450052 I have found and installed springs as per diagram found on webs, the drive pully is a cheap cast alum with punch points for woodruff key to engine shaft, is there an upgrade for this?? Have ordered OEM but I can see it failing the way it is made> Thanks

Gifted this mower, bad pulleys, and full of grass and dirt, removed back guard under gas tank, repaired broken gas tank vent, and need spring attachment diagram for two springs above trans for pedals, anyone have a clear pic? I know they attach to back plate unsure of pedal...

well thanks to you people I FIXED IT!!!! I listened and bought a walbro knock off, (hey it's retirement time ok?) cranked right up, no smoke no hesitation no coughing runs really good, it's a 2013, 12 /2013 to be exact, already hauled a trailer load of top soils with it. Thanks to all who...

yes when received mower last spring went thru it all new trunnions with bearings, blades all new belts, cleaned and flushed gas tank then also.

thank you for the info, I'll recheck that date code , was a little dirty to read on valve cover, it does have a nikki according to what I have read, it will be a few days before I can get back on it. Thank You.

here before you post all nasty again, I am pushing 70, I have 9 stents holding my heart working, 10 heart attacks, 4 mini strokes been shot 4 times and carry the scars from each one, my friends are all gone you know the ones who took or would take lead for you, So I came here for help, if I...

Here is model number,31R 001G1 139517zA, asked if carb goes to fuel tank, no carb intake has vacuum line from top of fuel tank from what is called a rollover valve, to carb supply air inlet adapter, I have a new comp tester coming tomm. was posted known for "blowing head gaskets". will ck...

well yes you are..........

listen, I want to thank all of you for the replys. I will get the number today I am up ay 4am most days have to wait for the sun a little bit this morn. Until I get out there, a little history, this mower was a gift for a rewire on a neighbors garage, he mislead me big time swore he had just cut...

sorry I didn't see the request for engine numbers give me a day.........I apologize.

been watching cordon's channel for a long while, been there and done that many times myself, problem here is using my skill against getting information, when I search B&S carb models for this engine all I get are part numbers, not actual jet sizing, then by chance if I am lucky I will find posts...

Ok lets go to my original question are these 15.5 BS low emission engines with Nikki carbs dialed in expressly for these 15.5 hp low emission engines, ??? that is my question.