Recent content by rajthepilot

Thank you. I've ordered this one.

Thank you both

I purchased a used Snapper Pro S200XT. For the past few years, I've been having a local shop change the oil, but I'd like to do this myself as I no longer have a trailer to take it to the shop and the shop's transportation charge is $90. I tried really hard, but I could not open the oil drain...

The diagram attached up in the message itself isn't showing anymore, so I'm adding it as an attachment

Thank you so much again for providing it. I actually found it at Briggs & Stratton Parts look up website. I had been there many times, but never noticed this. I wrote up full details of how the wiring works and I'll open up another forum and post it, so if any person stumbles upon it in the...

So the only question remains for now is that when the ignition is off, G & M & A at the ignition switch are connected. But what purpose does it serve to connect the A?

Scenario 2: Key is in "Start" position Ignition Switch B & L & S are connected. B is a red wire that receives power from the battery via the 20amp main fuse. A big red wire goes from the battery to the solenoid, but then a small red wire from there goes via 20 amp fuse to the ignition switch's...

In a forum 2 days, I requested some help regarding my mower's wiring. 'StarTech' was kind to help me with the diagram. I then spent hours looking at it and following my mower's wiring to make sense of it all and then I wrote down what I learn, to help diagnose it now and also in the future. I'm...

The diagram helped quite a lot when I went to manually go through the wires. I do have some more questions, but I'll post them if I can't figure out the schematic in another day or two. Thank you so much.

Once the engine starts, I can engage the PTO and I owed for about 4.5 hours last week. But it's just hard to know when it's going to crank. So I just keep trying with PTO on, PTO off, (it only starts with PTO off), but I have to try all these steps I feel. I don't know if the repair shop used...

Thanks

Thanks. Any particular type of oil?

Attached is the page from the manual that shows which parts of the ztr that need grease and which parts that need oil. My question is, how exactly is the oil applied and what type of oil? Does it come in the form a spray can? or do I put it in some bottle with a small nipple in the front and...

Hi All, Mower Info: Snapper Pro S200XT Professional, Model # 5901280. Engine Model Number: Briggs & Stratton 49T877-0010-G1 Quick Summary: Last year I changed the PTO switch because it had gotten loose. Later in 2023, the PTO clutch locked up and I had to have the repair shop replace it...

Will do