Randomly dying when mowing today. Though maybe a fuel delivery problem. When it dies sometimes I hear a metal on metal grindind similiar to your brakes when the pads are gone and your metal on metal. Seems to be lacking a bit of power too before it dies. Engine has oil and its clean, changed...
Pumps are getting worn out. Thought this moght be a good winter project. Neither pump leak that I can tell. One side is just way more powerful than the other. Should I rebuild or replace? And why?
TIA
Chris
Can I just grab any 3/4 wheel bearing for these? I can get a set of 2 at TSC for $13. The scag pn equivalent on the the zon is $15 for each bearing/race set.
We notice that as well, the serial number. And had to contact scag. Below is the info they gave us. Does this change your comments on what to check?
"www.scag.com/wp-content/uploads/2020/04/2004STTOPMANcomplete-03135.pdf
The above link will correspond with your machine. You will notice the...
Last weekend I noticed when I bounced up and down in the seat they would engage. That trick isn't working this weekend. If it was the seat switch mower wouldn't start.
I've done some research. I gapped the clutch to .015. I checked continuity on all the wires for the pto switch as well as cleaned all the connections. Checked continuity on the clutch it self. Mower starts, and drives fine. My only thought now is the module. Any other ideas?
I bought a used tt. The front right caster bearing was shot so I replaced it. It's helped a lot but I notice the left caster is always on the ground but occasionally the right side spins freely in the air until the terrain changes and it makes contact. I'm hoping there is a way to adjust this...