Recent content by Pondbound

Hi all, I am doing yearly maintenance on my husqvarna m-zt 52. This is for home use where I am cutting about 3 acres. Currently it has about 25 hours on it and the only thing I've done is replace the blades and change the oil. I am pretty much following the book but had some questions as...

Hi Folks, So the wifey kind of let gas can nozzle slip off can into the tank:ashamed:. I can't say a whole lot about it because I don't like sleeping in the dog house:laughing:, but my ocd is kicking in and I'd like to get that nozzle out of there. It's been in there a while (since last year...

Hey folks, I'm looking for advice. I unintentionally left 93 octane ethanol free gas in my Husqvarna mzt-52 over the winter. It's got about a half a tank that I meant to run out and "just kept forgetting" until holy crap it's time to get ready for mowing again. What should I do? Should I add...

Hi all, I wanted to ask how you vet a dealer and what your advice would be if you've made purchase from a dealer that refuses to support you after the fact. I confess my reason for asking is self serving. I recently made a $7,000 purchase for a ZT and a bunch of other equipment. (chainsaw...

Hi all, I may be crazy, but today I tried to change the oil for first time on MZT52 and I can't figure out how to remove the drain cap! (I'm at 12 hours run time doh...adds up fast...book says change at 8. Hopefully extra four hours won't hurt anything). So the mower has the little hose thing...

Hi folks, I just got a husqvarna 327ldx and a couple attachments. The prospect of using "low use" tools on one engine was very appealing. One thing I wanted to do was get another trimmer attachment and put/leave a brush blade on it. We have a lot of thick crap that grows along the fence line at...

Hey all, I wanted your opinions on a decision I am looking to make. I have found an awesome dealer who sells Hustler, Husqvarna, and Big Dog. We just bought a house and now I have about 2-3 acres of grass to cut. (versus 1/4 acre before! - old craftsman push aint cutting it...