Recent content by Peterplocket

Cheers AD, I'll have a look in the morning and get back to you.

Thanks for your reply. I'm not sure where the product info is. Do you happen to know if it’s quite easy to find?

Hi, I have a Mountfield MTF 84H riding mower. Does anyone know the best way to put a drive belt that's come off, back on? Any suggestions welcome!

Try the putting it in the bath when wifey is out! And make sure it's squeaky clean afterwards though! Rotate the tyre (UK spelling) slowly, checking both sides carefully. There maybe only one or two bubbles coming out slowly, so be vigilant. Also, make sure the valve is in tight, but not overtight.

Hi Everyone, Has anyone done this before?? Any advice/solutions welcome. But maybe I'll have to ditch the bad mixture and start again. If there is a workaround, I'd be v. interested. For instance, could I go ahead and maybe add a smaller proportion of 2 stroke? Would I end up wrecking my chain...

Hi Buddy D, Pleased to read your message re JDs! I'm on the point of buying one……costing me not much less than £2500! Previously I've had a Husqvana with B & S engine. Lasted over 20 years with very little trouble: one new cutting deck, a few new batteries and a few new starter motor gears - the...

Hi everyone, I have a fairly old Husqvana riding mower. A few years back I replaced the worn out cutter deck. The replacement deck is now about four years old and one of the blades' nut and bolt that secures the blade to the deck keeps working loose. Why this should be, I can't imagine. If...