outdoorpowermike's latest activity

You need to remove the black plastic lock on mixture screw and remove needle to clean port also. Don't forget to replace rubber orange...

If valves are adjusted right at .004 and stops cranking the compression release built onto camshaft is broken. Needs to be replaced...

The red wire at the ign switch plug is the 12 volt feed not the white wire. Put a test light at back side of wire harness and turn key...

Simple test. Without motor running Push throttle to fast position, then with your best finger pull back the governor arm, if arm has...

Nice to read that you are up and running again.

To figure out if you have a fuel pump problem just test pump as I posted earlier. Easy to do. This will conferm good or bad. Works every...

7 years is way past the life off the carb pump gasket. Sounds like engine is flooding out because carb gaskets are hard. This condition...

Ok now. You have a bad switch somewhere. Seat switch is 2 wires, jump across harness, try to start. if no start jump Brake switch same...

Make sure the tensioner pivot is not rusted and pulling all the way off. If not the brake pads will never touch spindle pullies. If...

Make sure the tensioner pivot is not rusted and pulling all the way off. If not the brake pads will never touch spindle pullies. If...

Sounds like float is getting stuck someplace with float bowl, causing needle not to work correctly. Maybe you should just get new carb?

Only purchase the tank from a 4/5 star rating seller. I've had same problem. Cheaper is just cheap. Good rating good product.

Nice to read that your running again.

ok, use a vac/fuel pressure gauge at fuel pump and test positive and negative readings. Pulse line should show 1 1/2 lbs. or more, suck...

Did you replace fuel pump yet? If so what was the outcome?