So there are a couple of things i need to weld up on the snapper before i proceed . One of the things needing welding is the gear selection lift yoke.
However i didn't have a welding cap to keep the spark and spatter out of my hair and ears, so i tried to make my own out of an old jean leg.
I...
well. first i would say
#1 check your blade mounting bolts to make sure the blade is mounted properly. If that is ok then.....
#2 check your spindle for looseness. If that is ok then......
#3 check the bolts that hold the shroud in place by the wheels, make sure they are adjusted properly and...
I thought about doing that but there was just too much metal in the grease
Looks like im going to need a new cover as well. this one looks like it would eat up any nylon washer i try to put in it.
I suppose... i could fabricate a piece or metal to lay down in there and then have it tack...
6 problems found in the differential case.
The "half shaft" or outgoing shaft is work out the internal bushings are worn and the outside of the shaft is worn. this is going to be kinda expensive to replace.
The internal nylon thrust washer is worn out as well as the metal washers for the...
It's Rustolium Cherry red
I got the decals from this link. Although the comet letters are too big.
https://equipmentdecals.com/products/snapper-comet-2680-decal-kit-1973-riding-mower
I have limited knowledge.. but from looking at the photos i would say even though you have cylinder and piston damage i would bet that there is a problem in the crank case as well. Possibly a main bearing or crank bearing.
Progressing with the rebuild. Finished rebuilding the front end. New bearings and tires and steering bushings. Painted the frame. The comet decal is kind of big. Working on the chain case today