Recent content by ncb1038

Thanks ill do it next oil change

The good news today on the situation. Cylinder 1 was the one gunked up. Cylinder 2 had no issues and could get the mower started but with the lack of valve operations due to gunk and as you stated bent push rods in cylinder 1 valve head cause the rich operations and stalling. I pulled the head...

On point with valves since i had time i pulled the left cover to begin checking and found the push rod bent for exhaust valve. Attempted to adjust it but then found that the valves were stuck. Ended up pulling the head off and found both valves stuck open due to carbon buildup ive managed to...

I thought the same but with the cub cadet ther version of the carb they use isnt adjustable as far as i can tell. I see no mix screws only available adjustment i can make is idle screw. As for correct carb i looked up the part in the manual and ordered it from amazon. It matches what came off...

hello everyone i have a cub cadet rzt 50 with a briggs and stratton engine on it. The model for the machine is 17ba5a7p709. the big issue i have so far is its hard to sstart, if i am able to get it running it may run up to about half to three quarter throttle before bogging out. a little back...