Recent content by moparjoe

  1. M

    Briggs and Stratton piston rings

    I'm wondering how much thinner the cheap china made Briggs and Stratton piston rings are going to get. I measured the top ring at .048. The older rings are .090. What's next.
  2. M

    Trying to get 190cc Briggs & Stratton to start - with video

    Several years ago I sold a mower to a guy that was attending college. I started the mower to show him it runs. The next day he brings it back and tells me I sold him a piece of junk, he used it for 30 minutes and it quit running and it wouldn't start. I reach over and take the gas tank cap...
  3. M

    Snapper LT-125 Mulch Plate - 42"

    Take a chainsaw and cut the trees down then you won't need any mulching blades and you also won't have to clean the leaves out of your gutters.
  4. M

    LT1046 won’t start

    STARTECH. I had the same problem a couple times with the fuel line from the tank collapsing and stopping the fuel flow. It's a heck of a lot cheaper than putting a electric fuel pump on just to find out it's the fuel line.
  5. M

    Trying to get 190cc Briggs & Stratton to start - with video

    Take the spark plug out and connect a plastic coated wire to the end of the plug wire and hold the end and pull the starter cord to check if your coil is good.
  6. M

    Are mulching blades about the same?

    The best way to avoid mulching is called A CHAIN SAW. Cut the trees down and you wont have to worry about mulching.
  7. M

    Mulching blades that can still actually lift grass?

    There sure is a kit that will solve you whole leaf problem, it's called a chain saw. Cut the trees down and you get rid of the leaf problem permanently. You also wont have to clean your gutters out either.
  8. M

    Starter problem

    Get rid of the mower and save yourself money.
  9. M

    Kohler 14hp K321S help

    Check the flywheel key.
  10. M

    Gravely 260Z - Rpm's bog down when moving under load

    Shorten the governor spring.
  11. M

    click,click and click

    It could be the armature needs cleaned, maybe new brushes or the solenoid is going bad.
  12. M

    click,click and click

  13. M

    click,click and click

  14. M

    Snapper won't crank

    The quickest way to find out if you have spark is take the sparkplug out, hold the plug wire and crank the engine over.
  15. M

    Tire pops off the rim

    Put an inner tube in it.
Top