Recent content by Mike12656

https://www.youtube.com/c/JimJacksonFixItShop-Woodworking/videos

I have 2013 33” Snapper RER I bought used and it was running fine for many years (Its a great machine) then I want to start it with the key and it would start After going through the safety switches-wiring-mechanical parts I finally discovered it was the the module I dont remember what I did (I...

Does anyone have a link they can send me to regarding a Kobalt 80 v lawn mower 6080-06 I looked all over the internet and haven’t found anything on these mowers I am looking for a video showing how to take it apart and fix Good luck right It runs for a second then shuts off And self propelled...

I was able to get the washers out replaced clutch and put it back together Now I have to start it wish me luck!

Well I drilled the old screw out got new screws at the hardware store so that should be good to go But by taking off that cover it didn’t expose the washers as expected They are still in there as far as can tell Next I take off gas tank I believe the washers are there between the gas tank and...

As always I turned something simple into a cluster $&@! Haha When I took off the old clutch I tried to make sure the washers behind behind the clutch came with the clutch unfortunately they did not they fell into the motor! I got 3 screws out the shroud and the third one is stuck I think if I...

Thanks for the info you provided I wish there was a video showing how take it apart The illustrated parts list leaves much to be desired as far as disassembly and assembly! I noticed the Southland Wheeled Trimmer is the same as the Powermate Wheeled Trimmer I think Powermate makes it or visa...

I have a Southland Wheeled Trimmer SWSTM4317.2 Last summer I replaced the fuel lines and primer bulb and got it running good This year I started it up and was using it and the trimmer was turning when I gave it gas But that all changed! As I as I was giving it gas (pushing down on the throttle...

Bert and Rivet I will try that what you guys said and get to you

Thanks I have that diagram and I been tracing the wires with it for about 45 minutes now I think I may just hook up the new switch and see what happens I may wrong about bad wiring—its all the original oem wiring Could the switch just be the problem the old one would turn not off the engine...

But should I check the wires going through tube for continuity Thats I believe where the problem lies not only is switch bad but the wire(s) or ground wire is shorting out

Yes I tested the kill wire and it killed the engine when I touched it to ground So I think I have a wiring problem I was waiting on Revits to tell me how put in a new switch Thats why I posted model/serial on mower- engine-switch Unless you can help me

Alright I have the numbers Snapper 3314520BVE Serial # 11348333 —————————— 14.5 hp Briggs and Stratton 287707-1235E1 Serial # 009182E thats info on what I have —-Mike