Recent content by mike coulter

Figured it out. Shear key was bad. Fires right up

Here they are

Standby and I’ll send them

I’ll get them tomorrow

Engine turns over but just won’t start and run

New carburetor, fuel and fuel filter has spark but won’t crank and run. any help would be greatly appreciated 🇱🇷🇱🇷

Well good news this morning Got the parts in this morning that were broken. I cut a new shear key. Got it back together and it busted off and ran on the second pull Thanks again for all of your help Greatly appreciated!! 🇺🇸🇺🇸

Without the washer and nut on it , it has slack in it. I’m going to install a new shear key tomorrow and see what I have

I just pulled the flywheel and it’s solid but it rocks back and forth as it’s got slack in it.

Yes sir I did look at it from the top Since you mentioned it I’ll pull the flywheel because it’s a possibility that it might be messed up on the bottom of it. It looks good from the top

I have a brand new Briggs and Stratton 7.25 eco engine on a push mower that has fire but the flywheel cup is broke off in two places.its made of plastic. Plug has a great spark Will this keep it from straying? Only had one tab left.

I replaced the left brake cable and that fixed it.

Here’s a picture of what I’m seeing

I don’t see any springs. Tried to upload a picture but even after reducing it it says it’s to large

Appreciate the information I’ll have to look and see when I get back home I’m not seeing item #22 though I see the 10 & 20