Hi guys,
I have a 2002 Stiga Park Pro DIESEL powered by Hatz Diesel 1B40W, S/N 1171102 001122.
The engine starts great from cold and runs very well for as long as you want, but will not re-start when the engine is hot. If I let it cool for a while it'll re-start OK and then it carries on...
Hi Guys,
I was servicing the Mikuni twin-choke carburettor from a GCV520 engine (GJAKM-1053057) which is installed in a Honda lawn tractor HF2315 HME.
After disassembly I noticed that the two rubber caps on the main bleed pipes were broken off - perhaps it happened when I inverted the carb to...
Hi all,
How do you guys tie down lawntractors on a trailer so the tie-down straps don't bounce loose?
No matter how tight I get the ratchet straps, one or two always seem to come loose.
I know how they're coming loose but I can't find a way to prevent it. The trailer is a 7x4 with sides &...
2013 Husqvarna LTH154. It has a Walbro LMK carb fitted to a Kohler Courage 15HP [597cc SV470-3212, S/N 4304637623 build date 15/2/13].
Fuel is collecting inside the air cleaner housing and dripping on the floor - not a large amount, but concerning nonetheless. (I suspect it may be entering the...
I really hope someone can help me out here, I'm having a real struggle to get this engine running.
The symptoms are:
Very hard to start - it "catches" readily but won't run;
- it splutters, misfires very badly and spits & pops back through the air cleaner;
- with much perseverance I can get...
I want to order a carb repair kit, or perhaps even a replacement carb if they're not too costly, but I can't figure out what part number this Walbro carb is.
It's off a 1992 B&S 12HP I/C, 283707 0217-01 92070211 (Type -01 doesn't seem to exist according to most sources so I've been using...
Tanaka THT-2000 hedge trimmer blades shudder at full speed.
Background
Water had got into the gear-case over the winter, causing the drive pinion and bearings to rust and seize solid.
I replaced the clutch drum & pinion assembly and both bearings, and cleaned up the cutters, the oscillating...
I have a Tanaka THT-2000 hedge trimmer which the owner left out in the rain. Water got into the gear case and rusted-up the drive pinion bearing. It's taken several days of soaking with penetrating oil and "gentle persuasion" to free it off. It's turning now but it's rough & notchy and needs...
Hi guys, can anyone tell me what the correct idle and maximum rpm should be for a 10.5 I/C engine?
Year approx 1998 and Engine ID is: Model 28B707, Type 0146-01, Code 970318ZB and the carb is a Walbro LMT 5-4993.
Thanks
Briggs 10.5 fitted to a customer's 1998 CastelGarden F72 ride-on, motor was running fine but now runs rough and is near impossible to start with air filter fitted.
Model 28B707, Type 0146-01, Code 970318ZB
Carb is Walbro LMT 5-4993 (no fuel cut-off solenoid)
Mower came in for battery not...