Recent content by matt.fleisher@vailrubber.

MParr Thanks!

Finally, received my new front wheel fork, got it installed. Leveled mower deck per instructions and mows nice! Next I have a left leaking wheel motor. Where should I get them and what will they cost? I think I will replace both sides at one time? Thanks Matt

Well, Closer inspection last night, my right front wheel fork(I don't know the proper term) is bent and has been welded and some grinding done on it, I have ordered a new one and will install when it gets here and continue with the deck leveling. Matt

Well, I guess better run it through again tonight and see what I missed. I report back. Thanks Matt

Rivets, Never really measured deck height after I was done with leveling, checked blade level from front to back, but deck has to be at least 1 1/2 to 2'' lower in the front.

Yes, this is what I used! Tire pressure at 13 psi. All scalp wheels remove and 3/4 block put under brackets. On the best concrete floor I have and checked the floor with a 4' level. Any suggestions? Just about 3/8 low from the front underside of the blade to the back underside of the blade. Hope...

Hello, New here to this forum. Just purchased a 2007 LAS28KA724 and also my first zero turn and a rookie on these. I have leveled the mower deck per the manual, but the front of the mower deck is way lower then the back. With all the scalp wheels off it's not a 1/2 off the ground. I...