Recent content by macdoesit

LOL

Yes, I have 5 acres that is not level

I willhttps://www.lawnmowerforum.com/attachments/img_20250611_115650811-jpg.71109/ just use it for parts or buy a new engine for 1,400.00 and keep it as a backup mower.

Bought a new 54inch cut JD yesterday. These new ones ride like Cadillacs, and cost about the same. LOL

Took valve cover off. one exhaust and intake pushrods, one was laying under rocker arm broke, the other I assume is in the bottom of the engine. I ordered both rods, both valve tappets. Is there anything else I need to order? Can rods be replaced without breaking down the engine?

Compression is at 88 and no bleed off

If that was the case, wouldn't it make a loud knocking noise while running. It does run but only on one cylinder. I did take the spark plug out and started it and air came out of the cylinder.

Bought new in 2010. one cylinder is dead. I took the ignition coil and sparkplug and switched them around, the good cylinder fired but the dead cylinder is still dead. Can anyone tell me what the problem is?? Thank you

(y)

I'm going to weld some steel plates and swivel casters to the deck, that are height adjustable.

My mower is a 54" cut JD Zero Turn. I have 5 acres that are uneven, hills, dips. I have gone thru lots of anti scalp wheels because when turning they dig into the lawn. I have been mowing my property for 25 years and have not been able to fix the problem. I have reset the wheels to every...