I’m seeing on the parts diagram that some have the spacer and some do not, I’m gonna have to check mine and see if it has the raised center or not then go from there.
That’s kinda what I figured, I’ll try and get my hands on a torque wrench to make sure that’s correct.
If we assume that it was torqued correctly and it is still being stripped out, would the spindle be the next thing to look at?
I can’t say for certain cause I don’t have a torque wrench, but I have gotten that thing fairly tight from what I can tell. I would “assume” the shop would have torqued it correctly when they replaced it, but that pulley only lasted 3 hours before it stripped out again.
I’ve got a Z254F that is eating through mandrel pulleys. I’ve checked the spindle and everything looks good, the splines on the spindle look good. Any other thoughts or ideas to try?
I let the shop take a look at it and they agreed everything looked good, they replaced the pulley and it...