Recent content by Kevin1970

I have it running again. I can only assume when my starter fried it somehow shorted all my safety switches. All of them had to be replaced. The reason after replacing all of this and then my fuses kept popping was that I put my solenoid ground on same post as the yellow wire not realizing it was...

The only time I don’t pop fuse is removing that yellow wire from solenoid

Replaced the ignition and PTO switch still blowing fuses when I turn to start. I pulled the negative cable off battery and put test light on post and to wire and no light until I turn to start position. Hook negative cable back on turn to start pop fuse. Now when I unplug the yellow wire from...

Ok replaced ignition switch and pro switch and nothing. The fuse wires are no longer getting hot and the fuse isn’t blowing. The only thing you here when you turn the key is the carburetor click. So do you think it is a safety switch????

I have looked at everything and I see no bad wires. I have unplugged every switch. I was told the ignition switch or the pro switch could’ve gone bad. Just weird it happened while mowing.

Thanks so you think that would cause it to just die while mowing?

Also when I turn key all the way to starting position both wires on the 20 amp fuse gets very hot

Here is photos of solenoid

Thanks soon as I get home this evening I will try to post photos. I will replace fuse holder as well I have to buy more fuses anyways.

New to forum mower issues?

Was mowing then it died. I pulled up seat to check fuse and the 20amp was blown and very hot I pulled it out and the Fuse housing melted a bit. It will not do anything. Keeps blowing fuses. Put in new battery, new solenoid, new starter because it was completely shot. Now nothing. Turn on key you...