Recent content by Kba9

Bought some muratic acid, it's taking quite a bit of effort with a soft metal pad to take it off.

https://ibb.co/dBGfyXw https://ibb.co/5rt2X0D Is there a way to take the metal off the crank. This is from the top counter weight. Left alot of metal almost welded together

https://www.ebay.com/itm/153768425198 you think this would be cheaper option?

Yeah it's been take off. But there's still metal left from it

Ok so i started taking a look at it again. I noticed that there was no ring on the top counter weight and it was stuck in the crank. I managed to get it off but there's metal still stuck on there. Do you believe this is the problem? And is the crank done? https://ibb.co/Jty857X...

The shaft seems to be in pretty good condition. Should I just order a new piston rod and start putting things back together. Also do I have to lube the shaft up and how do I re-time it.

Not that I can tell

https://ibb.co/9wqprYk https://ibb.co/XVKsr9z https://ibb.co/QmGTGmP https://ibb.co/RbJLTmR https://ibb.co/fdxZVzZ Worth mentioning that the piston connecting rod is cracked and both sides. I took a picture of the crank, is this where I should be checking for deep groves, where the connecting...

Could you send me an example of a rod and cap bearing

Never mind. Everything is out. https://ibb.co/d0wHTPT https://ibb.co/J5jg1Ps

I've taken the top con weight out. And the piston completely out. Just can't get things pulley off.

I can't get the pulley off. No matter which way I turn the bolt it just spins but won't loosen

https://ibb.co/mRpyRws Ok what should I be looking for next?

https://ibb.co/gy9Gg3W Can't take it out, I tried unbolting from the bottom of the pulley and no matter which way I turn it won't loosen up.

Not sure if it's seized. I can wiggle the rod side to side