Recent content by johnny7

Image resizer http://www.simpleimageresizer.com/ Resize 75% Video size reducer Online Converter - Convert Image, Video, Audio, & Document Files (freeconvert.com) Reduce to 50%

try a different browser, Firefox, Chrome, Edge. I run into some sites that just work better with a different browser.

After getting this unit running, I go to test the mower part of the tractor and when I engage the PTO switch (pull out and flip up), the mower goes to shut down. It's as if the key is being turned off. I do have the wiring diagram. And side note, see that the seat connector has a piece of wire...

thanks ALL for the great advice.

That sounds like a big job that I don't have the equipment to do. I'm making the assumption that this would need to be done only if there were issues with the transaxle? The mower is dated but runs great. Whoever had it before my bud did, took care of it but I don't want him to experience issues...

Tomorrow, I will get back under and see if I can see. I will take some pictures at the same time. Pictures always seem to help

I just repaired a John Deere 108 lawn tractor and is running good but I am not sure (and can't find anything on this) if the rear end transaxle gear housing oil should be changed. First off, I can't see a drain or some place to fill it so that would probably be my first question - where is it...

excellent, thank you for this

PIN: C108L 194364 M / 108 TRACTOR

Hi all, I have a C108 lawn tractor that won't start. Battery is good, turning the key, there is no click from the relay/solenoid. The ignition switch feels mushy but without a diagram, I can't tell if it's a problem or not. I am looking for an electrical diagram so that I can chase the issue...

I'm going to check to see if I can get the brake link or not but if I can, do you know how to replace it?

Homelite Timberman45 Chain saw Engine: PS-05867 Model UT10946D I have a Homelite UT10946D 18” chain saw that won’t turn because the chain brake is too tight. When the hand guard is disengaged, the brake band is still too tight around the drum. If I pull the hand guard back just a little, the...

any update to your issue? I'm following and curious as to the resolution.

Yes, for sure and at that point, in my diagnostics, where it doesn't fire, is where Step 5 would be, to pull the flywheel and check the key. In my pre-diagnosis, before I do anything, among other items I look for, I check the condition of the blade. If I see a big divot out of it, and the mower...

I've been fixing small engines now for just a couple of years as a hobby and have picked up lots of things along the way. With the problem that you are having, here is what I would do in this order 1. the very first thing I check for is the oil to find out what condition it's in or if any exists...