Recent content by Johner

Ever thing above sounds right. Chains must be tight they must over lap the inside wall tighten the adjusters. After that this is what I put on Mine on the outside of the tire, elastic cord from a parashot cord dealer tie and stretch cord tie to opposite side use about six of them. Chains been on...

Right, it does not stop vaporization, from what I read it keeps air from entering the tank that holds moisture from collecting in the alcohol that keeps it from gelling. Can give a 2 year protection. Have worked on generators that haven't run since the storm Sandy 10-12 years ago what a mess...

Yes there are many things. Worn throttle and choke shafts have never so far ran into that problem.

Most carb. problems can be solved using Fuel Stabilizer. Not one customer came back after sub jesting it and I know it was not for sure what I charged to do the work.

Another carb problem came about fixing a customers machine, under those metal plugs inside the carb are fuel channels some with a ball bearing check valve can get plugged from setting to long. If you want to trouble shoot and see the problems use a fine tooth comb to find them.

This is something happened to me. Toro wood chipper, Ran great end of season. Next time I ran it would not run without choking. Persistent to find the trouble on the third time taking apart the carb, on the main jet covering one of the small holes in the main jet there was s peace of gasket...

Why did the crank break? assumed you hit something and now the key is offset on the fly wheel. Replace the key.

Will almost guarantee the high speed jet has dirt in it. Are very small holes along the jet could be plugged or the main jet that screws into it is plugged , or open the jet with a screw driver. If you get a new carb sometimes that jet has to be drilled out with carburetor drills.

I have an older Kohler similar problem hard starting in idle, until you increased the throttle. Inside the carb there is a jet that has 2 O-rings very small. Bottom O-ring was cracked, replaced O-ring and all is good. The jet is removable about 1" or so long.