Recent content by John34

Yes, I have a somewhat similar, cheap, ill designed way to drain oil on Toro Timemaster Kohler. I’m going to replace the drain line with a braided piece and the Stens drain plug. Better than original, I think. Purchased on Amazon. Hope that helps. Stens 125-508 Oil Drain Plug , Black

Will try that. Should of treated underside of deck before first cut. Doh!

Thank you for your input. At this point, looks like I will need to stay with the original blades, as they seem to be proprietary on this model for some odd reason.

Good advice, will do that. Thank you.

Thank you for going the extra mile, and researching the blade to fit my needs! Sounds perfect, will give them a try. I loved the Gator on my 21” Toro Recycler trimmer. Very much appreciate the extra effort.

Thank you for going the extra mile, and researching the blade to fit my needs! Sounds perfect, will give them a try. I loved the Gator on my 21” Toro Recycler trimmer. Very much appreciate the extra effort.

Thank you for all your good information! Will start looking tomorrow, armed with that knowledge. Thank you again for your reply!

Thank you Sir, makes it that much easier to get correct blade, and not worry about my math.

I have a Toro 34” Zero Turn Timecutter (75740), and was wondering if anyone had any success in finding a Gator or Copperhead blade that may offer a better cut than the original blade? Never was a fan of the Toro recycler blades. Here is the Toro Blade pt. number. 140-5134-03 It is a 17.5” x3”...

Thank you so much for your reply, will remove a blade, and make the measurements!

Will do, thank you once again for all your help and advice.

Thank you for your reply. Will use Full throttle now, and check Oregon for replacement blades.

I have a new Toro 34” Timecutter, with 4 hours on it. Don’t like the cut, need to go over same area twice at times. Any recommendations on aftermarket blades? Does mower need to be run at full throttle? Was breaking it in, and using slowest ground speed, half throttle so, don’t think that was...