Recent content by joboy1937

Thank you very much !!!

does anyone know the flywheel bolt size for a kawa FH 721 v. I can't find it in any documentation.

I have a sick Kawa fx729v-cs17-r in my Fastrac. anybody know what a currently available replacement engine might be. I can't find any new engine with this number..

It's me again' I need to replace the clutch on my Super mini 25 hp kawa. I ordered a clutch using Hustler part even though the picture did not look right. Sure enough the clutch that arrived is upside down. The clutch I took off is Warner # 5218213 and has the pulley on the engine side and...

25 hp kawa ok I've got the mower back together and it starts and run fine But I think I have a bad diode in the clutch pigtail. I ordered a new one by Hustler part no. The pigtail I received had the wrong connection config on the switch side. My question is Where is the diode? Is it...

I have a Super Mini Z with 25 HP Kawa I am trying to identify the electrical components shown on the schematic with what I see on the mower. I see the 3 relays,3 safety switches & the Pto/clutch switch. there is another compoent on the control panel with 2 gray wires and 1 black. I...

I have a Super Mini Z w/25hp Kawa I believe I have a relay problem(starter will not engage). The question is- are all 3 relays under the control panel the same part number (026237)? Thanks

I have a Super Mini Z with 25 hp Kawa . When installing the centrifugal clutch the clutch has 2 stop slots. does it matter which of these I use?

I have a sick fh721v-es-24s in a Hustler super mini Z It appears that this engine is no longer available Does anyone know what the replacement engine would be? Thanks

I have a kawa fh721v 25 hp mower starts and runs fine but after about 15 minutes the engine light starts to flicker then gets bright red. the oil level is full. I have remover cowling and cleaned engine and fins. I noticed when it starts the light flickers but when I reduce the revs it gets...

I have a super min iz with a 25 hp Kawasaki I just replaced the starter but I find a loose white wire with a green stripe .it is a fairly heavy gauge wire that originates somewhere under the carb and the other end is loose. i'm afraid that it plugs in somewhere around the top of the starter...

mu hustler 25 hp kawa just clicks when I turn the key. I have replaced the battery, new solonoid and rebuilt starter. I have 14 volts on the battery side of the solonoid. Is the stsrter solonoid and starter relay 2 diffirent animals. if so where is the starter relay. I can turn the flywheel so...