Recent content by JKQ

Did you find a way to test interlock module PN# 7028606? I have one of these rear engine snappers and was trying to figure out why it wont fire

I'm looking for a reasonable top end kit for a STIHL MS 361 chainsaw.I'm retired and costs are out of this world and I don't want one that is too cheap as I don't want to have more troubles later,Someone posted some good prices months ago but I can't seem to find it now,Thanks

I'm looking for the torque tightening sequence pattern and torque pattern

Thank You

Anybody know what the valve clearances are supposed to be on a Briggs & Stratton Model# 08P502-0169F

I have a Craftsman YTS4500. when you engage the PTO the fuse broke engine was running ok.How do I verify the PTO is either good or. bad electrically

Are mulching blades designed to be used with a grass catcher that's mounted on the back for the mower?

I have a Murray Mod#42598X92. If you try to engage PTO it goes dead,If you let up on Clutch pedal it goes dead,When you disconnect the carburetor solenoid it runs and you can mow but it won't cut off. Only way to cut off is by reconnecting carburetor fuel solenoid wire connector,NEED HELP!!

So sad to see the decline of Western society and Innovation

Is this a rear wheel you are working on? Are there two holes on each side of the arbor? Get a puller from a parts store insert all thread in holes and push against he wheel,Penetrating oil and tighten center bolt to push wheel oof of drive shaft

Thank you, it was where you said it would be.The serial # I found is 0028680,Sticker says it's a X2303 Quad Loop,With a 60" cutting deck.What service manual should I buy?

It has a sticker that says X2303 , Quad Loop. if there is no stamped serial# then what is my option?

There is no sticker on the right side of frame.The sticker under seat area where serial number would go only has 2 zero's on it.This is a Model# X2303 with a 60" cutting deck.I'm hoping the # is stamped somewhere? Any help would be greatly appreciated.

Thanks for the reply

I have a Honda that's on a MTD frame, The engine has GTAE-1711713 stamped on the side,Am trying to determine which model this is ,It also says 160cm3 on the end of it