JimP2014's latest activity

Thank you for the reply dark here now but tomorrow morning I can get going on that flywheel is torqued down to I think 90 90 foot pounds...

One thing I forgot to ask am I focusing the video on where those springs are or on the other side where those push rods are? Thanks,

I will make a video of this bump or non bump, I am leaning more towards no bump ( bad ) but I do not know for sure.

Bentrim I do know what you speak, and I was wondering that. A few years ago I watched a video by FNGuitar player ( something like that )...

This is the video of that rocker arm shaking here is the video of the rocker arm shaking I'm not sure if when it's not under tension it...

So I checked all the linkages + they seem fine I took off the valve cover gasket the exhaust valve specifically that hex nut and that...

Wow good points. I am on autopilot with this thing and not paying attention - Thanks! "lower valve while turning the engine over you...

So the latest is it runs so erratically as soon as you start the engine it seems like after ruling out the flywheel key it has to be a...

The noise it was rattling that had to do with a belt guide that has been fixed. So I took apart the cylinder head portion of the...

Yeah now that I know what it is and I'm reading what you're saying that's the noise it's a scraping noise it's not that easy to bend...

I just wanted to give an update on that rattling noise so it turns out the front left belt guide is in close contact with the pulley for...

So I put the belt back on over the belt guide the one for way up front the drive shaft mower deck pulley and the noise goes away...

So I tried what you said and nothing changed and so I tried to kind of get on the ground and make a long story short something to do...

Hello thank you very much I will try that tomorrow. Jim

I changed my mind it's not a rattling noise it's more like a wild boar but it's real unfortunately.