JimP2014's latest activity

I see there's a lot of videos to watch on the lt2000 brake clutch assembly hopefully this solves the problem but thanks for various...

Just to follow up on this I never actually started the engine I just sat on the seat and kept pressing the brake

So I went to get on on the riding mower just to start it up I pressed a break in and then I take my foot off the brake there's this...

I appreciate this additional comment about the break it's interesting because it's like you just slightly take your foot off the brake...

"Noise while driving could also be ground drive belt idlers" < --- thanks for this, they are most likely original from 15yrs ago or...

So I made the clutch cable tighter, and that lever slide to engage the blades happens now without any noise. I know better not say this...

I think removing the deck at least 10 times, so far I got it down to under 3 mins. I remove the chute guard, place an old air matress...

I did look at that a wek ago. But I was actually thinking about looking at that again today, you convinced me. I actually only have one...

Freddie I will I have done that a dozen times or more and here is what I know: I have a brand new 'pretty' red colored belt that got a...

If you notice it's rusted it's been this way for years it never made a noise and now that everything's perfect there's constant grinding...

What I mean to say is in all the schematics on paper one seems raised shaft and the other seems recessed shaft I got to figure out what...

So today the same problem when you engage the blades there's this grinding type of noise then it goes away and then it's a constant...

This might appear twice do not know why

Latest video and mostly audio. I have replaced both spindles, brand new belt and only one pulley. Everything seems to spin fine, meaning...