Recent content by Jeepbut

Thanks for all the help.

Can I run a new ground wire from module to a push button switch that is grounded to use just to kill the engine? I can't find any problem with the wire but can't access most of the wiring.

Okay, I'll check that out. Thank you. So, the kill wire is nothing but a ground when the key in off position?

I got it off. Disconnected wire to module. Stronger spark than before and continuous spark as long as engine is turning. Is the wire going to the module a full 12 volts? do I have a short or broken wire or is there a resistor that could be bad? Thanks again.

I can't get the blower housing off. Seems like all bolts are out, it feels loose, but won't lift up. Any ideas?

Thanks ILENGINE. I will try that.

Engine serial # 3515227461. Was mowing with Dixon and engine died as if I turned off the key. I have plug wire on ignition tester with plug out. When I hit starter I have spark for about 4 revolutions, then no spark. I can wait a little while and try again, same results, spark for about 4...