ILENGINE's latest activity
-
ILENGINE replied to the thread New Hustler Group.The spring pulls the slide one direction the belt against the idler pulley moves it the opposite direction. And the idler pulley slide... -
ILENGINE replied to the thread Carburetor question.Allows small changes to the idle fuel mixture, but won't smooth out more major problems with running
-
ILENGINE replied to the thread New Hustler Group.I would say you are missing the spring that goes from the front of the idler pulley bracket with the U and the U that is in the deck...
-
ILENGINE reacted to Rivets's post in the thread STOP! A surging engine is not the governor, when will people learn? with
Like.
The real problem here is that most DIY guys really don’t know how a small engine works, especially carbs. They think that it takes too... -
ILENGINE reacted to Auto Doc's's post in the thread STOP! A surging engine is not the governor, when will people learn? with Like.
I see this issue on a daily basis and read about it on the forums. "My engine surges up and down".... So, you are standing there...
-
ILENGINE reacted to slomo's post in the thread Husqvarna 350 chain saw no spark unless i remove spark plug with Like.
Open the tester gap to 0.25" or 1/4" wide minimum. Should jump this gap if the coil is good. No spark with kill wire disconnected...
-
ILENGINE replied to the thread Husqvarna 350 chain saw no spark unless i remove spark plug.It looks like you have confirmed that the original module is bad, and sounds like the new replacement module may also be bad. And most...
-
ILENGINE replied to the thread Briggs & Stratton OHV Plastic Engine No Compression.Either have to lap the new valves into the seats or have a seat cutter set like the neway. I have the Neway seat cutter and valve face...
-
ILENGINE reacted to Tiger Small Engine's post in the thread Briggs & Stratton OHV Plastic Engine No Compression with Like.
I don’t even know of a machinist in our area that will grind valves. When you factor in your time back and forth, and paying labor cost...
-
ILENGINE replied to the thread Bad Boy Maverick HD right tank not flowing.Something is goofy. The parts diagram shows a 3 way valve but the service manual shows a 2 way valve with the on-off lable for the...
-
ILENGINE replied to the thread RPM Surging.Carb needs a thorough cleaning or a little more technical explanation. A carb has two fuel circuits. The idle circuit and the high...
-
ILENGINE replied to the thread Briggs Carburator Help.According to Briggs the molded fuel line is 791766. The carb should be a 591925 but references a part requirement that isn't used on...
-
ILENGINE replied to the thread Craftsman YTS 3000 with B&S 331877 1234 B1 emits blue smoke under load.You are in the early stages of a blown head gasket. Blown head gasket between the cylinder wall and the push rod cavity is the second...
-
Can you provide the manufacturer label information of this yard machine along with the engine information stamped into the top of the...
-
ILENGINE replied to the thread This is the stuff that makes small shops look bad.Order a carb kit and accelerator pump kit for a Rehlko Command CV730 last week and just got around today to pulling the carb. and found...