ILENGINE's latest activity

That is a hydrostat with foot control. Husqvarna, SBD, JD all have that setup available. Just need to look around.

Have you checked to make sure there isn't gas in the float making it sink and not stop fuel flow at the float needle. Floats on...

I am surprised that this hasn't been noticed before. This isn't exactly a new mower. I think there was a 3rd party involved...

Actually the small wire ring is suppose to slip over the fuel line install the fuel filter and then slip the wire ring down over the...

The starter will turn backwards and keep the bendix in the down position if the battery connectors are reversed. negative to positive...

That is how they are supposed to work. The idea is to allow tank venting to remove the vacuum created by fuel leaving the tank, to...

I wonder who had the bright idea to make the oil pressure warning light on the dash blink when it corresponds with the CHG OIL display...

The rollover check valve is a 2 way valve and is only supposed to stop venting when turned upside down. So the non venting fuel cap...

I agree. It sounds like the rollover vent valve is not working because if this mower has the vapor recovery line connected to the air...

Got the Amazon carb installed, which is not my desired choice, due to quality control in most cases, but anyway the new carb allowed...

Little behind the times. SBD purchased the other 20% in 2023.

And the MTD name is now being replace with SBD outdoor. Stanley Black and Decker Outdoor.

4.10/3.50x5 is approximately 11 inch in diameter. So maybe narrower than the spec'ed tire but same height.

Front 11x4-5 4 ply rear 18x9.5-8 4 ply

Husqvarna