Recent content by howdydoody
-
H
No crank,gifted someone else's mightmare
Thanks to all I'm ready to start trying to put wires back to PTO clutch and reassemble the deck. A 8 pole PTO switch put my solenoid to trying to start engine with key,a different battery made starter spin engine,she fires as soon as she starts turning. This is a wonderful site with a lot...- howdydoody
- Post #9
- Forum: Troy-Bilt
-
H
No crank,gifted someone else's mightmare
- howdydoody
- Post #8
- Forum: Troy-Bilt
-
H
No crank,gifted someone else's mightmare
Will check soon as I find my tester- howdydoody
- Post #7
- Forum: Troy-Bilt
-
H
No crank,gifted someone else's mightmare
The parking brake is on however haven't tested brake switch,brake light on in run but goes off in start,seems to be working as should(I have little to no experience on safety switches or electrical systems. When you said deck engaged are you referring to PTO switch? It is in off position. The...- howdydoody
- Post #4
- Forum: Troy-Bilt
-
H
blade engage sensor/switch
Newbie here,posted my first post minutes ago. Will the problem being discussed here cause the PTO/blade light to come on when key switch is in start position. If so sounds like my problem also? Sorry if I'm infringing on bm3groovy's post- howdydoody
- Post #9
- Forum: Troy-Bilt
-
H
No crank,gifted someone else's mightmare
Model 17af2acp001 Serial 1d088g20302 Jumper cables to bat- starter+ = start and runs. Replaced solenoid after it tested bad with used one I had after it passed bench test(auditable click with continuity across big post). Both are 4 wire. Will not click after installation this starter doesn't...- howdydoody
- Thread
- Replies: 8
- Forum: Troy-Bilt