Recent content by gsueagle22

Thanks. Turns out one of the coils was touching the flywheel not allowing the magnet offset to move by, must have shifted when I tightened down the opposite side and I didn't catch it. Re-set it and also lined up the magnet to the first ignition coil and closed everything back up. Cranked on...

No, I didn't loosen the flywheel nut or bolt. Just rotated it. Any idea where I can find the gap distance spec between the flywheel magnets to the ignition coils ? I'll make sure the magnet is also facing the modules, that may be the issue. I put a business card in between it to gap it so...

I am looking for a little guidance on how the flywheel on my engine needs to be positioned. I had an issue with the engine running very rich after it ran about 2 hours, and was able to figure out I had a bad ignition coil. Had 750 hrs on the original set, decided to change them both out while...