Recent content by Greystone123

Hello to all, Is there a 42” deck for a Scott’s brand mower made by John deere, that is interchangeable? Spindle bolt holes have rusted out. Thanks in advance

Thank you for this info. Still need to find where to buy the tools for this.

Not sure which one of these I would need for the Husqvarna k760. Any thoughts? Thanks

Thanks you all for the responses. I will definitely keep all in mind.

I don’t get enough rebuilds to acquire such an expense.

Thank you, but there has to be a cheaper alternative.

I’m looking to purchase a crankshaft puller to pull it through the bearings once they are installed. Does anyone know where I am purchase one of these? Thanks in advance

Hello everyone, Can anyone tell me the best/accurate laser thermometer gun to purchase to read engine temps Thanks in advance.

Thank you

Thank you to all

Hello all. I purchased new tires for my zero turn mower, and cannot get the bead to seat all the way in place. The previous tires had tubes, and I wanted to switch to tubeless. I have tried everything from wd40, dawn dish soap concentrate, ratchet strap, pb blaster, as well as inflated to 90 lbs...

Yes, it’s vibration free without pto, and yes it turns freely, but has some resistance due to pressure disc on clutch. I’ll try your methods and see if I can tell/see any difference. Thanks for the feedback. I’m at a complete loss on how to diagnose.

Old pto clutch had vibration due to pressure disk not on correctly. Customer brought mower with this issue. Replaced the clutch and new anti rotation stud, and the still had the vibration and broke the stud. Any ideas what could be wrong? I’m stumped. The shaft doesn’t lol bent, but hard to...

Hi everyone, I have a Briggs & Stratton 15.5 hp. I have replaced the battery, starter, solenoid, checked all connections, switch, adjusted valves, flywheel key way/coil gap, etc. If I turn the engine by hand all the way to the left until it stops, and then it will start. However, when I turn it...