Gord Baker's latest activity

You stored it without any gas, but did you run the fuel completely out of the carburetor as you stored it?

I believe at least 2 of the Flat Idler pulleys are loose and need replacement . Put the front deck control arm back where it was and...

I suggest a fuel diagnosis. Sounds like it is running Lean. The usual suspects, carb/filters. Check Valve Lash.

Be sure the Bendix shaft is well lubricated.

MAP gas is still obtainable and is much hotter than Propane.

doesn't crank is about a helpful as doesn't work. Do you know how to troubleshoot do a basic testing of a battery charging and starting...

Tire could have been Rotted too........

Leave Rim leak detection for a few minutes before looking. I use Windshield Washer fluid or Snoop if you can get it. Don't forget the...

Well done. Check the belt for correct WIDTH. To narrow = too loose. Get a new one from Dealer of proper size. Check Spindles and...

Sounds like the battery needs to be load tested to make sure it has enough amperage. A multimeter only reads voltage. Voltage is only...

The Bore looks to be in very good condition. Be sure Valve Guide clearance is adequate. What gauge were you using to check...

Another opinion I see a perfect bore (for a mower). Have had many pushers with way worse gouges and piston rocking. Little smoking is...

Do you know what the red grease is for? It is a "sticky" version of grease. Red = sticky. As in it doesn't flow. As in it doesn't move...

Bearings come in standard sizes. Buy a set of quality bearings and don't over tighten.

On some machines IF you have a Reverse switch, the wires can rub on the Manual Shaft under the dash and short out.