Gord Baker's latest activity
-
GGord Baker replied to the thread John Deere D125 mower broken belt now noisy..Be sure that the belt is the correct WIDTH as well as length. I just restored a LA125. Belts also wore through the guards. I pop...
-
GIs the float valve rubber/Viton in good condition? I there any fuel "varnish" , other crap, on valve tip/valve seat? 😈
-
GGord Baker reacted to rickpaulos's post in the thread Cub Cadet GT 1554 just clicks won't turn over with
Like.
I had to replace one of the battery cables that connects to the solenoid. For some reason one terminal kept dissolving the bolt & nut... -
GGord Baker reacted to GearHead36's post in the thread Cub Cadet GT 1554 just clicks won't turn over with Like.
Does your solenoid have 3 connections? Or 4? All solenoids will have 2 large terminals for carrying the heavy current from the battery...
-
GGord Baker replied to the thread How to stop cut grass blades from accumulating inside mower cavity?.Sell the E mower.
-
GI just went through that last week. I cleaned the carburetor, emptied and cleaned the tank. I removed the ignition module and cleaned...
-
GGord Baker replied to the thread M-ZT 52 Stops running when hot!.Remove Fuel tank Cap and fuel line at filter. Blow back the line carefully with minimum pressure. Do this outside, off the driveway...
-
GOriginal tire spec's - - - Front tire = 410/350-5, 4 PLY Rear tire = 18x9.5-8
-
GGord Baker replied to the thread 54 inch riding mower just clicks, won't start.Disconnect the present Battery and try a known Good Battery. Engage Parking Brake, handles in Start Position. Then start checking...
-
GDead battery. PTO switch is on. Faulty safety switch. Blown fuse. Bad ground.
-
GGord Baker replied to the thread Toro mower raising handle bar.I suggest you take it to a repair shop and ask them or have them do it if possible.
-
Gwhynot, could you post a photo of the mower, even one maybe to routing of the deck belt on the mower, gosh there is enough of us skilled...
-
GGord Baker replied to the thread 8 inch stripe longer grass being left?.Likely a 42" deck with 2 Blades.
-
GRemove valve cover, as previously stated, and look at intake and exhaust valves. Are push rods in place and not bent? Are the springs...
-
GGord Baker replied to the thread 8 inch stripe longer grass being left?.I suspect one of the spindles is seized a bit and/or Belt is too loose. Get it up in the air and with Blade rotation OFF, reach under...