GearHead36's latest activity

This is the Husqvarna forum, so... yeah. Those specs don't match my machine. They must have made a change at some point. Mine has a...

Thanks, ILENGINE. The rears are right, but I'm not sure about the fronts. They are currently Kenda Corsas, and size printed on the...

I have a CZ 4817, and the tires are fairly old and leaky. I just deal with it by putting air in them every time I use it. I recently...

Sounds like the governor spring is either wrong, or installed wrong. 4800 should be out of the range of adjustment. I'd look over the...

Do both mowers run the same RPMs? Are both air filters clean? Or, the same amount of dirty? Same blades? High lift blades will use more...

To those saying that you don't need to be in the seat for starting.... Some do, some don't. I have two riding mowers. A Husqvarna CZ4817...

I can't keep the angle consistent enough with a flap wheel. I really like the idea of soaking blades in water for ez clean up. Why...

I just put my blades in vise, and use 60 grit flapwheel on drill...then cone balance First I soak them in pan of water for ez clean...

You might try one of these. I just ordered one, so I can't comment yet on how well it works. It's a much cheaper knockoff of a tool that...

Beware the grass clippings They can be very dangerous...

Modify a Cold chisel to approximately the race radius and drive it out .

As the book says Grease is cheap parts are not

I never mentioned a temperature difference anywhere. Where are you getting this? I plan on keeping it well greased.

CC claims that it's a commercial unit. That year, they offered a Pro Z 100, 500, and 900. I consider mine to be "entry-level commercial"...