Forest#2's latest activity

If it has a low oil switch at the bottom, on the side of the block, unplug it and see if it will start when hot. These switches were...

I also call them Briggs starter c clips JESUS CLIPS. When I pry it off carefully and it goes flying high and me listening for where it...

I worked office for 16 yrs and cam across a lot clips and rings. I have come across Speared End snap rings when I was tearing the 4L60E...

Does it have the electric starter also?? Them 10 HP Tecumsehs are not user friendly to rope crank is why I ask.

You got lucky in a way, maybe. Keep a heads up around the hydro drive pulley. If the belt comes off in that area it will sometimes ruin...

No Hydro's have a Neutral lever usually on the rear of the machine that allows them to be pushed. If it's set for push it will not...

might think about getting some fuse holders and fuse each individual circuit, for example place a 10 amp fuse in the PTO clutch circuit...

Make sure the push lever on the back of the tractor is positioned correctly. If it is might try jacking it up with both rear tires...

You can't use a metal to replace the plastic if the flywheel gear is plastic or aluminum. It will eat up the ring then you have get a...

Quite often a bad aluminum flywheel ring is what starts eating the fiber starter gear and it only takes one bad tooth on the flywheel...

Idler pulleys should have very little vertical play.

I find that running a little 2-cycle fuel mix at the end of the cutting season works very well for all of my mowers. I do the same.

Even running an engine till it stops from no gas. There is still some left in carb fuel bowl, gotta remove bowl to have it completely empty

I have replaced the twin tower ignition coils on some emergency generators during a emergency and the gen needed immediately by using...

At least remove the blades while you are fooling around off the tractor with the deck blades turning and taking videos etc. You are...