Forest#2's latest activity

Appears to be maybe at least two issues. For ONE We already know you are probably not getting a compression release IF the...

The problem I have is most of the washers that I get in with bad pumps are the vertical style with the special short crankshaft that...

Wait until you have one blowing the ignition coils at random. That one can get expensive fast.

And they fail to winterize them. Surprise surprise. That is where most of my good tiller and wood splitter engines come from.

On carbs that are dirty/gunky on the outside if I cannot remove enough of the gunk by hand cleaning first I sometimes give them a heated...

From looking at your picture of the carb with the throttle plate visible , I think I would turn the idle speed screw out till there is a...

The model number indicates a single cyc OHV engine, but your first post seems to indicate two cylinders?? post up the complete model...

On some similar rims that are rusted to the axle I've taken a very large threaded nut and welded to the rim and use a large bolt...

After the plastic pipe is warmed and pressed onto the rim I use shoe goo to seal the pipe to the rim and then install a 90 degree...

Set down in the seat and test if you are still standing up. But disable the PTO, apply brake, and don't breath. Might still be under...

Put a break over bar with socket on flywheel nut.

Is why use a low pressure setup. The HF one only uses 15 psi to get to the full scale set mark. With it I can hold the flywheel with one...

Check the kill wire where it goes into the kill terminal to make sure it is opening enough not cause this problem.

Amen

I agree. Bring back the Briggs Lhead twin engines.