Recent content by fayjim2

Its a 14 tooth, will it come with the bendix spring a Thank Yound that bearing and clip at end of the shaft.

While waiting around for new Starter to arrive I disassembled it. I cleaned the Commutator and checked all segments OK. Brushes looked good Magnets tight and in place. The bearing ends looked awful dry so I applied a small amount of lube. The gear bendix moved fairly free but had what seemed a...

Lets be a little bit reasonable, If you are stupid enough to be run over by the turning deck maybe its better that they don,t produce offspring. I was referring to safety switches that stop the engine from starting/running. I fully realize that safety is sometimes trying to protect us from...

Why so many safety switches, are they really all that neccessary? Which ones actualy stop engine from starting ,electric and fuel from flowing? The seat switch has been unplugged for years now. Can I just disarm them? I just got a kit for the Walbro but I need to get the engine turning first...

Ok Now more problems It ran fine for 30 minutes drove around and Dethated yard. Parked next day hard to start but finally did. Drove to barn to get trailer and engine started to hunt rpm up/down. I went back to garage shut off looked over machine and tried to start. No start even with a shot...

Installed new aftermarket Carb. Won,t start unless spray fuel down the throat. Where does power to the solenoid come from and is there a fuse somewhere for this circuit. I believe the solenoid isn,t allowing fuel to flow inside the carb Help?

Thanks

Kohler 19 hp Model SV 590S Spec SV590-0220 SN. 4005615513 DOM 02/25/2010

My LTX 1040 has a Leaking Carb. At first it was just a drip from the solenoid area. This year when I fueled up it must have leaked thru the needle because when the air filter was removed fuel drained out. I need # for replace or rebuild to include all gaskets and orings and solenoid. The carb...

I need to rebuild or replace the carb on my LTX 1040 with the 19hp kohler engine. It has leaked from what appears to be the Solenoid. This year when I fueledup it must be leaking thru the needle. I removed the Air Filter and fuel ran out. So I need advice and parts # for a complete carb or a...

So tell me what bar/chain assy to buy Thanks

The Drive Sprocket has 7 teeth,does that mean what as far as chain/bar assy?

Hello Somebody out there knows something about this saw Help

I found it at a dump site. No bar/Chain and trigger lock is missing. So where is the S.N. located? I found no tags other than EPA and Saw shop decal. Would like to know what year of manufacture. I have no way for a photo/ What size bar/chain 45 CC Air Induction Thanks

So what should I check out. The belt has some wear but it works just fine in the higher settings . I guess I need to know why the deck doesn,t raise straight up rather than moving up and to the rear?