Recent content by Ezvalet

Good morning! Thank you. Haha. I was Very confused when it wasn’t on that diagram. I hope that your having a great weekend!

Good evening!!!! Thank you soo much. That is the little plastic arm I was looking for! I hope your having a great weekend!

My apologies - I was looking at it wrong. That is the piece! Thank you soo much!

Thank you for taking the time to look into this. Unfortunately, the end is supposed to be closed for the linkage to connect to it and hold. Here is a photo of the exact set up / not broken Almost Identical to what you found minus the open end

Good afternoon. I have an issue with a craftsman mower that I just picked up The choke mechanism is like an electric choke. The small hole in the black plastic piece is broken and Iam unable to connect the choke linkage ….. I looked on parts tree and found the yellow electric / solonoid...

Awesome! Thanks again

Hmm. Interesting thought. Have you tried that before ? I will give it a shot tomorrow

thank you. It was very difficult to reach the bolts. They were pretty much deep and under the flywheel. Ferris engineers / definitely didn’t think about performing maintenance or service. There is not much room to fit a socket in there ( the side plate of the body is only a few inches from the...

Good afternoon Can someone tell me - how to reinstall a rear shock on a Ferris. It needs to be compressed a bit to get the bolt holes to line up. Thanks in advance.

Thank you. Unfortunately this Ferris / doesn’t have much room between the metal side frame plate and the starter. Iam trying to remove the flywheel - to see if I can see and access the bolts better. This machine has sat outside a long time and this flywheel is not wanting to come off

Good afternoon! Iam having trouble removing the starter - so that I can install a new one. Does anyone have any tips on how to get to the bolts and what tool is needed? I can’t even see them. Thanks in advance

Thank you Mark! Have a great week. Happy Holidays

Disregard

Good afternoon! Are there any videos on how to replace the drive belt on a Murray select? I have the belt off of the rear - however I can’t remove it from the clutch...I don’t know how to loose. The steering rod to pull it up a little ( if that’s even how to remove it ) just guessing...