Recent content by Dixiemilker

I did replace the fuse holder, not with a marine one though, it is keep under a shed. Thank you for your advice!

That fixed it. I had continuity with my ohm meter, but the fuse connector ends had gotten hot and lost their tension to hold fuse good.

Thank you! I will check it today.Ilengine-The clutch is not engaged and it I remove the battery wire on regulator wires don't get hot.

Should add less than 1 ohm resistance from regulator to ground and battery negative to ground. I don't usually ask for assistance but am stumped by this one.

Should be.2 ohms between the white wires from stator.

I am working on a kawasaki engine that is blowing the charge fuse. The stator is putting out 32 VAC at WOT. There is no resistance to either stator wire to ground. .02 ohms between the two white wires from the stator. 12.04 volts from switch wire to regulator. 15VDC from regulator going to...