DanAyo's latest activity

I’ve been using a 3” piece of dowel. I can easily guestimate the extra length in the rear.

I’m good for all of your suggestions. Imagine a (36” x 54”) 1/4” steel plate with hook eyes at each corner. If you lifted the plate by...

There are 5 links at all 4 adjustments and on level cement. All links are the same kind.

Everything looks good to me. The remaining adjusting chain goes slack amd will not allow the deck to lower anymore.

I think I may have to settle for good enough is good enough. I can get 3 points set but the last adjustment at the rear needs to go...

Personally, I don't like the rear being 1/4" higher than the front. I don't get a good clean cut with the deck set like that. I get a...

Yeah, I edited my post. Usually, the blade tips are 1/8" higher than the bottom of the deck. So, you need to determine the difference on...

Thank You, so for a 3” height I’d cut 2 @ 3 1/8nand 2 @ 3 3/8. But I think the problem is that when I lift one side of the back, the...

I wanted to check the deck adjustments on my LazerZ S series.I want to try a 1/4” rise on the rear of the deck. But one blade tip is 3...